Hyundai has initiated a safety recall encompassing over 12,000 Genesis Coupe models manufactured between 2010 and 2013, specifically targeting those equipped with manual transmissions.
The recall stems from a potential defect in the ignition lock switch return spring, which could fracture and inadvertently cause the vehicle to move when started in gear.
This issue came to light following customer complaints and regulatory inquiries, prompting a thorough investigation. Hyundai’s probe uncovered three instances of accidents involving these vehicles within the United States, fortunately without resulting in injuries or fatalities.
The affected Genesis Coupes were produced at Hyundai’s primary manufacturing facility in Ulsan, South Korea, and incorporated ignition lock switches supplied by the domestic automotive component manufacturer, INFAC.
While initial assessments suggested a low incidence rate of the defect, subsequent analysis led to the decision to recall the affected vehicles to ensure the safety of Hyundai customers.
Hyundai has issued a safety recall encompassing approximately 12,612 Genesis Coupe models produced between 2010 and 2013 due to a potential safety hazard. An investigation revealed that these specific models share a unique clutch pedal design that can prematurely wear down the ignition lock switch return spring.
This issue was addressed in March 2012 with an improved spring design, hence the recall’s exclusion of vehicles manufactured after April 9th of that year. Extensive field data validates the effectiveness of the revised spring in preventing ignition lock switch failures.
To mitigate the risk, Hyundai will conduct a comprehensive recall, replacing the entire ignition lock switch in affected vehicles at no cost to owners. This proactive measure underscores Hyundai’s commitment to vehicle safety and customer satisfaction.
